Bondit 3M VHB License Plate Tape, pack of 12

Each roll is supplied as 12 license plate tapes measuring 9.5 cm length × 3 cm width. Eliminates drilling and screwing. Does not damage the vehicle. High adhesive strength. Easy to use, no special skill required. Resistant to external conditions such as pressurized water, rain, mud, humidity, moisture, high heat or cold. Safe for use. Application instructions: - Clean and dry the vehicle surface where the plate will be applied and the plate itself. - The surface where the tape will adhere must be flat. Do not apply on sloped or curved surfaces if the plate does not sit fully flush. - Ensure the plate is straight and not tilted. - If both the contact area and the plate are flat and make full contact without gaps, the tape is suitable for application. Peel off the film backing of the tape and stick it to the plate first. Then press the plate firmly onto the vehicle surface. - After applying the plate, continue to apply pressure by hand for a short time. - The tape bonds instantly; no drying time is required. - To remove the plate, pass a filament/wire under the edge of the plate and slowly pull downward to separate the tape from the plate.